Mitsubishi Electric FR-F862 Instruction Manual page 39

Control circuit
2.6.4
Wiring of inverter control circuit
Control circuit terminal layout
2 5 4 1 F/C +24 SD
AM 5 10E 10 SE SE

This terminal functions operates as terminal CA.

The X10 signal is assigned in the initial setting.

No signal is assigned in the initial setting.
Wiring method
• Wire insertion
Use crimp terminals and stripped wire for the control circuit wiring. For single wire, the stripped wire can be used without crimp
terminal.
Connect the end of wires (crimp terminal or stranded wire) to the terminal block.
(1) Strip the signal wires as shown below. If too much of the wire is stripped, a short circuit may occur with neighboring wires.
If not enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder it.
(2) Use appropriate crimp terminals (ferrules, blade terminals, etc.).
Insert wires to the crimp terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the crimp terminals after crimping. Do not use the crimp terminals of which the crimping is
inappropriate, or the face is damaged.
• Crimp terminals commercially available (as of January 2017)
Phoenix Contact Co., Ltd.
Wire gauge
2
With insulation sleeve
(mm )
0.3 AI 0,34-10TQ
0.5 AI 0,5-10WH
0.75 AI 0,75-10GY
1 AI 1-10RD
1.25, 1.5 AI 1,5-10BK
AI-TWIN 2  0,75-10GY
0.75 (for two wires)

A ferrule with an insulation sleeve compatible with the MTW wire which has a thick wire insulation.

Applicable for terminals A1, B1, C1, A2, B2, and C2 only.
38
INSTALLATION AND WIRING
∗1
So SOC SD SIC S1 S2 PC
RUN SU IPF OL FU PC RL RM RH RT AU
∗3
Wire strip length
10 mm
Without insulation sleeve
-
-
A 0,75-10
A 1-10
A 1,5-10
-
A1 B1 C1 A2
STP MRS RES SD SD
(X10)∗2
Crumpled tip
Damaged
Ferrule part No.
-
AI 0,5-10WH-GB
AI 0,75-10GY-GB
AI 1-10RD/1000GB
AI 1,5-10BK/1000GB
-
B2 C2
STF STR JOG CS
∗3
Unstranded
wires
Wires are not inserted
into the sleeve
Crimping tool
For UL wire model No.

CRIMPFOX 6
