Table of Contents
Advertisement
PAGE 22
Operating Your Dishwasher (Continued)
CHANGING THE PROGRAM
Once the dishwasher has started a wash cycle program, you can change the selected program within the first
minute or so, otherwise the detergent may have been already released. When you start a new program, the
dishwasher will drain any residual water, hence you will need to re-fill the detergent dispenser in the event that it's
already dispensed it.
To change the program within the first minute, press the Start/Pause button and the dishwasher will enter it's
standby state. Press and hold the Program button for 3 seconds. You can now press the program button to cycle
through the programs and select an alternative wash program. Once you've selected the new program, press the
Play/Pause button once more to start.
The colon symbol between the Hours and Minutes remaining (i.e. H:MM) will flash intermittently once running
again.
Note. If you open the door during a wash cycle, the dishwasher will automatically pause. The colon symbol
between the Hours and Minutes remaining (i.e. H:MM) will stop flashing to indicate that the dishwasher is in
standby mode. An audible tone will sound every 1 minute until you close the door. After you close the dishwasher
door, it will automatically resume its wash program after 10 seconds.
Caution! It is dangerous to open the dishwasher door during operation. The hot water or steam inside can easily
scald you.
FORGOT TO ADD A DISH
A forgotten dish can be added any time before the detergent dispenser has been released.
Step 1 Press the Start/Pause button to put the dishwasher into standby mode.
Step 2 Open the door a little, allowing for the spray arms to stop spinning, before opening the door fully.
Step 3 Add any forgotten dishes or cutlery.
Step 4 Close the door.
Step 5 Press the Start/Pause button for the machine to resume its program after 10 seconds.
AT THE COMPLETION OF A WASH CYCLE
When your dishwasher has completed its wash program cycle, an audible tone will sound for 8 seconds, before
stopping. Follow these steps for optimal drying performance.
Tip! The colon symbol between the Hours and Minutes remaining (i.e. H:MM) will be solid (i.e. not flashing/
blinking) to indicate the program has ended. The LED next to the Program Ended Indicator will also be illuminated.
Step 1 Switch off your dishwasher using the Power button. Turn the water supply off at its tap.
Step 2 Open the door slightly (around 50mm) to allow for the steam to escape. Leave the dishwasher for 15
minutes where possible, to allow for your dishes to cool a little. This will also assist the drying process.
Step 3 Unload the dishwasher, starting with the lower basket rack first, before unloading the upper basket rack.
This will help to avoid water dripping from the upper basket rack onto your lower dishes.
Note. It is normal for the dishwasher and it's racks to be wet inside. Plasticware will not dry as well as ceramic
crockery, porcelain or metal cutlery, as plastic by nature won't get as hot nor retain heat in the same way. Due to
this, plastic very rarely dries within a dishwasher.
Caution! Be careful when opening the dishwasher door. The hot water or steam inside can easily scald you.
Advertisement
Table of Contents
