Table of Contents
Advertisement
Operating Your Dishwasher
TURNING YOUR DISHWASHER ON AND STARTING A WASH CYCLE
Step 1 Load your dishwasher according to the guidelines in the Preparing Your Dishwasher section of this manual.
Step 2 Load the dishwasher detergent dispenser (refer to section Preparing Your Dishwasher in this manual).
Step 3 Close the dishwasher door and press the Power button to turn on your dishwasher, located on the control
panel.
Step 4 Press the Program button (located on the control panel) to cycle through the various dishwasher
programs, to select your desired wash program. It will cycle through the options in the following order: ECO >
Glass > 90 Min > Rapid > Pre-wash > Intensive > Heavy > ECO etc. The LED will alight alongside the corresponding
program selected.
Step 5 (optional) Add any additional options to the wash program, including Half Load or Extra Drying.
•
To activate the Half Load function, press the Half Load button.
•
To activate the Extra Drying function, press the Option button.
Note. Extra Drying cannot be added to the Rapid or Soak programs.
Step 6 (optional) Add any Delay start, if you would like to postpone the wash cycles start by 3, 6 or 9 hours. Simply
press the Delay button to cycle through the options.
Step 7 Press the Start/Pause button to start the wash program, using the settings you've selected.
Tip! Whilst your dishwasher is operating a wash cycle, you can pause the program at any time by pressing
the Start/Pause button. To un-pause, simply press the Start/Pause button once again and it will resume its'
wash program. When the dishwasher is in its paused status, the colon symbol between the Hours and Minutes
remaining (i.e. H:MM) will stop blinking and be displayed solid.
PAGE 20
Advertisement
Table of Contents
