Table of Contents
Advertisement
PAGE 10
Installation Instructions (Continued)
WATER SUPPLY AND DRAIN CONNECTION
Cold Water Connection
Important! Your dishwasher should only be connected to the cold water outlet. It has an in-built heating element
to heat up the water to the required temperatures depending on the selected wash program.
Connect the cold water supply hose to a threaded ¾ inch tap connector and make sure that it is fastened tightly
in place.
Important! If the water pipes are new or have not been used for an extended period of time, let water pass
through them into a bucket until the water runs clear. This precaution is required to avoid the risk of the water
inlet becoming blocked or dirty water damaging your new dishwasher.
Figure 5- Connecting the supply hose to a ¾ inch tap.
Note. If your dishwasher is not going to be used for an extended period of time, please turn the water supply to
your dishwasher off at its supply tap and switch off its power supply at its power outlet (or unplug the appliance).
Connection of drain hose
The ideal connection of the dishwasher waste pipe is straight on to your sinks' PVC waste trap pipe with a
dishwasher spigot- an example of which is shown below in Figure 6. Also refer to location A in Figure 7, showing
this connection method.
Figure 6- Typical waste trap from a sink with the dishwasher spigot.
Advertisement
Table of Contents
