Site Requirements; Plumbing; Water Treatment; Counter - Bunn Fast Cup Installation & Operating Manual

Bean-to-cup single serve brewer

Hide thumbs

Table Of Contents

Table of Contents

Plumbing

Brewer must be connected to a cold water system with operating pressure between 30 and 90 psi

(0.206 and 0.620 MPa) from a

greater than 90 psi (0.620 MPa) to reduce it to 50 psi (0.345 MPa).

NOTE: Bunn-O-Matic recommends

more than 25 feet from the

facilitate moving the brewer to clean the counter top. Bunn-O-Matic does not recommend the use of a

saddle valve to install the brewer. The size and shape of the hole made in the supply line by this type

of device may restrict water flow.

Water Treatment - for best results include:

1. No Chlorine.

2. Water hardness 6 to 10 grains or less total hardness.

3. Water Filtration System. BUNN Filter EQHP-10L (PN 39000.0001)

FOR INDOOR USE ONLY

Counter

1. Counter able to support at least 200 pounds (90kg).

2. Counter area large enough for machine.

3. Minimum clearance of 2˝ around machine.

4. Machine must be level within 2˚ for proper operation.

5. Confirm all legs are flat on counter surface.

NOTE: Legs can be twisted to raise or lower.

WARNING

The brewer must be disconnected from the

power source until specified in Initial Setup.

Refer to Data Plate on the Brewer, and

local/national electrical codes to determine

circuit requirements.

Electrical Hook Up

CAUTION:

Improper electrical installation will damage electronic components.

1. An electrician must provide electrical service as specified.

2. Using a voltmeter, check the voltage and color coding of each conductor at the

electrical source.

3. Connect the dispenser to the power source.

4. If plumbing is to be hooked up later be sure the dispenser is disconnected from the power

source. If plumbing has been hooked up, the dispenser is ready for Initial Fill & Heat.