The Reset Switch; Local Management Console - Cabletron Systems MMAC-Plus 9F106-01 User Manual

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown
in Figure 2-2. It serves two functions:
•
•
SNMP management may be used to disable this switch to enhance module
security.

Local Management Console

Local Management is accessed by attaching a management console at the RJ-45
CON port of the 9F106-01. The console connection supports a Digital Equipment
Corporation VT 320™ terminal or PC emulation of one of these terminals.
Table 2-1 lists the setup requirements for the local management console. If your
terminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to access
the Setup Directory. If you have a terminal emulation of the Digital Equipment
terminals, refer to your equipment user manual for setup procedures.
Pressing the Reset switch twice within three seconds causes the processor to
reset.
Pressing and holding the switch on for three or more seconds causes the
module to shutdown. Pressing and holding again for three seconds restarts the
module.
Figure 2-2. The Reset Switch
Reset Switch
SMB CPU
The Reset Switch
2-3