Table of Contents
Advertisement
MANUAL - UG2000DM SERIES SPRAY GUN CLEANERS
Prevent Solvent From Entering the Air Passage of Spray Gun:
insert the plastic plug into the air fi tting as in the photo
below . Positive air will fl ow through the passage way
to the cap during cleaning. If the air passage way has
a a male fi tting attach the knurled female nut to
prevent sovlent from entering the air passage way.
This fi tting is located on the chain with the
trigger clamp.
•
Close the lid of the spray tank
and turn the "Auto Wash Timer"
clockwise as in photo below
to initiate cleaning. The wash
cycle takes about 60 seconds.
•
MANUAL WASH
Open the lid and remove brush from its holder on the back wall of the wash tank.
Step on the foot pedal. A dedicated pump delivers wash solvent through the brush, left photo below.
To control the flow of solvent through the Brush, adjust the Flow Control, also on the front of the
unit, right photo.
• The spray gun can be washed with the brush before or after "Auto" wash.
•
Dry the spray gun thoroughly.
REPLACING SOLVENT:
•
Replace the solvent when the solvent has lost its cleaning
eff ectiveness or after approximately 100 cleanings.
•
Close the drain valve (horizontal position).
•
Remove the pail of used solvent. Dispose of the used solvent
in a manner compliant with the laws in the municipality.
Return the pail to the cabinet and install the suction hose and
drain hose to the pail. Pour 5 gallons of new clean solvent into the
cleaning tank to drain to the pail in the cabinet.
REVISED 2018-12
Plastic Plug insterted into the air
passage way of the spray gun
Drain Valve in
Closed Position
Advertisement
Table of Contents
