External Paging Amplifier; Station Configuration - Tech Works MC-IP Series Manual

External Paging Amplifier check box is set for each 116 to tell it to either use the built in
20-watt amplifier or an external amplifier connected to the 116. If the External Paging
Amplifier is set "On", then each time the 116 is told to page it will automatically activate the
built-in page relay and connect the External Amplifier screw terminal inputs to the Station
select bus. If this feature is set to "Off" the built-in page relay will not activate and the internal
20-Watt amplifier will be used for paging program amplification.
Connecting an External Paging Amplifier
CAT6 PATCH CORD
#18 PAIR
Tech Works PA-402

Station Configuration

To get a better look at the options, let's split the screen in half and zoom in on the left half
first.
Enable Tells the system that this Station is to be used.
Station ID is hard coded and set by the position of the rotary switch on the 116 as described
above.
1/24/2021 Tech Works MC-IP-Series System Planning & Installation Manual Page 20 of 32