Mc-Ip-Odc Connections - Tech Works MC-IP Series Manual

MC-IP-ODC Connections

Static protection such as static bracelets MUST be used at all times when any of the
products are opened and vulnerable to electrostatic discharge.
All Of the connections for the MC-IP-ODC are inside the console for security purposes. By
removing the 6 cover screws on the sides of the ODC the top will easily tip forward. Run the
CAT6 cable connector through the grommeted opening at the back and plug it into the ODC.
There are 2 mounting holes provided to secure the console to the counter top if desired. It is
always best practice to install the counter mounting screw without power applied in case you
drop a screw or a tool.
The only user settings inside the ODC are the network ID rotary switch and the address shift
jumper P4 labeled "OPT !". The rotary switch selects the address 0-15 and by moving the
OPT 1 switch to the "ON" position the rotary switch sets the ID to 16-31.
Replace the cover.
Operation:
Apply power and make sure that the power light on the front of the console comes on.
Whenever an ODC microphone is active the Push To Talk light will light and whenever the
speaker is active the Reach lights will light up.
Console conversations are established through the control touchscreen. Once a call is
connected the Reach lights should come on to indicate that the speaker is active and you
should be hearing the distant remote station. To increase the Listening sensitivity, push the
"Reach Up" button repeatedly will make the remote louder. If it is too loud, pressing the
"Reach Down" button repeatedly will turn the remote down.
Depending on the software configuration of an ODC it can be called by another ODC. When
one ODC calls another, the calling ODC will control the direction of the conversation with its
Push To Talk button. The Called ODC will have its Push To Talk (PTT) light on to tell the
operator that they are being listened to and when the caller pushes their PTT button the
called station PTT light will go off and their Reach light will go on.
1/24/2021 Tech Works MC-IP-Series System Planning & Installation Manual
NETWORK
DATA
CONNECTOR
NETWORK ID
SWITCH
NETWORK ID
SHIFT JUMPER
MOUNTING
HOLES
COVER SCREWS
TYPICAL OF 6
Page 11 of 32