Advertisement
Commissioning
Before plugging in, check that the rated mains voltage and mains frequency, as stated
on the rating label, match with your power supply!
Attaching the additional handle: Always work with the additional handle attached (4)!
Secure the additional handle by screwing it tightly to the left or right.
Use
On/off switch, continuous activation
Caution!
Always guide the machine with both hands.
The machine must not be allowed to draw in additional dust and shavings. When
switching the machine on and off, keep it away from dust deposits.
After switching off the machine, only place it down when the motor has come to a
standstill.
In continuous operation, the machine continues running if it is forced out of your
hands. Therefore, always hold the machine using the handles provided, stand in a safe
position and concentrate.
Switching on/continuous activation: Push the sliding switch (1) forward. For continuous ac-
tivation, now tilt downwards until it engages.
Switching off: Press the rear end of the slide switch (1) and release.
Setting the belt speed
The belt speed can be preset via the setting wheel (2) and is infinitely variable. The positions 1–6 cor-
respond approximately to the following belt speeds:
1. 2.7
m
/
s
2. 3.8
m
/
s
m
3. 5.1
/
s
4. 6.3
m
/
s
5. 7.6
m
/
s
m
6. 8.5
/
s
Replacing the sanding belt
Release the tensioner arm (5) and remove the sanding belt (6).
Place the new sanding belt on the rollers such that its direction of circulation (arrows on the in -
side of the sanding belt) matches the arrow (7) on the gearbox.
Release the tensioner arm (5).
Ensure that the sanding belt is completely on the rollers.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61966
Page 5
02
2021-1
Advertisement
