Settings; Date And Time; Inverter Number Change; Language - Ingecon SUN 125 U 208 Outdoor Installation Manual

Installation manual
MP VIN
MP FRED
MP VRED
MP VARISTORES
MP AISL.DC
MP INT AC RMS
MP TEMPERATURA
MP CONFIG
MP PARO MANUAL
MP B VPV MED
MP HW_DESCX2
MP IAC INST
MP CR. FIRMWARE
MP LEC ADC
MP CONSUMO POT
MP FUSIBLE DC
MP TEMP AUX
MP PROTECCION AC
MP MAGNETO AC
MP CONTACTOR
MP RESET_WD
MP LAT ADC
MP ERROR FATAL
MP FALLO RAMA1
MP FALLO RAMA2
MP FALLO RAMA3
MP PI CORR SAT
MP LATENCIA SPI
MP REDUNDANTE
MP PROTECCIÓN PIB

8.6. Settings

Date and Time

From this menu you can change the date and time. The internal clock automatically changes the time from summer
to winter and vice versa.

Inverter number change

From this menu you can assign the node number to the inverter. This is required for configuring communications.

Language

With this option, you can select the display language.
In the main screen, press the "down" key (an arrow pointing downwards). Main menu access.
From the main menu, by pressing the
lighted, press to access the submenu.
Within the "SETTINGS" submenu with the
option. Once highlighted, press
ABB2000IKI01
High input voltage from the panels.
Incorrect grid frequency.
Incorrect grid voltage.
Varistor fault.
DC insulation fault.
Continuous overvoltage on AC output.
Overtemperature in the power electronics.
Shutdown for configuration change.
Manual shutdown.
Low input voltage from the panels.
Internal fault.
Voltage surge on AC output.
Shutdown due to firmware change.
AD converter (internal) reading fault.
Insufficient solar radiation. Does not trigger alarm.
Input fuse fault.
Redundant temperature sensor fault.
AC Protection.
Thermomagnetic circuit breaker error.
Contactor failed to close.
Stopped for Watch Dog reset (internal).
Converter (internal) fault.
Fatal error in the inverter.
Power electronics fault.
Power electronics fault.
Power electronics fault.
PI current saturation (internal).
Communication fault with redundant system.
The redundant system has caused a shutdown.
The PIB has caused a shutdown.
or
or
to access the language change screen.
keys or navigating through the menu to "SETTINGS". Once high-
keys or navigating through the menu to the "Language"
Ingeteam
69