Remote Triggering Kit; Heating Element Kit - Ingecon SUN 125 U 208 Outdoor Installation Manual

Ingeteam Installation manual
When this kit is installed in the unit and powered by 220 ~ 240 Vac 50/60 Hz, the display will be operational, allowing
users to navigate through the menus and access the inverter via communications, but the inverter settings may not
be changed until the voltage of the PV array is within the MPPT range.

5.6.2. Remote triggering kit

Supplied as an optional kit designed to open the grid connections remotely (by triggering the grid connection thermo-
magnetic circuit breaker).
To activate the coil that trips the thermomagnetic circuit breaker, just close a volt-free contact in the remote activa-
tion terminals. The contact must be able to work with 220 ~ 240 Vac 50/60 Hz and 150 VA power, except for the
INGECON SUN 125 U 480 Outdoor, where the power is 50 VA.
This kit does not provide remote resetting. The unit must be reconnected manually.

5.6.3. Heating element kit

In installations in which the minimum ambient temperature may be less than -4 °F (-20 °C), it is recommended
that a heating element kit be installed. (1) Units including this kit may be installed in locations with a minimum
temperature of -13 °F (-25 °C).
The heating element is supplied from 220 ~ 240 Vac 50/60 Hz; should the unit not have an auxiliary services kit,
this supply should be connected to terminal strip XAUX. It is protected by a thermomagnetic circuit breaker, with a
circuit-closing current of about 8.5 A. The current when the circuit is closed is approximately 8.5 A. The temperature
regulator should be set to 32 °F (0 °C).
The heating element power is 550 W.
The connection terminals allow 0.10 mm (2.5 mm) cables.
Heating element
56 ABB2000IKI01