Table of Contents
Advertisement
Ingeteam
4.3.1. General risks existing and preventive measures
Impact against immovable objects
•
Inform workers of the risk
•
Adequate lighting
•
Work with care
•
Keep sufficient distance to prevent contact with the part causing the risk (control rod in the isolating switch
door).
Knocks, punctures and cuts from objects and/or tools
•
Keep the door closed unless working inside
•
Adequate lighting
•
Order and cleanliness
•
Mandatory use of hard hat, safety footwear and gloves when necessary.
Flying particles (fan)
Recommended use of anti-impact glasses when accessing the fan area.
Electrical risk
•
Follow the instructions in the section on PPE and "4.2. General safety precautions"
•
Inform the worker of the risk
•
Comply with applicable regulation and legislation.
4.3.2. Additional risks and measures in handling tasks
Thermal contact
•
Inform workers of the risk
•
Recommended use of gloves
•
Disconnect the power and wait 10 minutes for the hot parts inside the unit to cool down.
4.4. Type of tasks to be carried out
The preventive maintenance tasks for the electrical panels involve Inspection, Control and Handling actions, depending
on the case.
Accessing the housing through any access point other than that described in this manual is strictly prohibited.
To open any of the covers of the enclosure (side, rear, top or door) the main power supply outside of the box must be
switched off.
4.4.1. Inspection tasks
Definition: Involves opening the enclosure for visual inspection tasks.
4.4.2. Handling tasks
Definition: Tasks involving the assembly and/or replacement of parts as well as changes to the setting of panel compo-
nents. Any task that does not fall under Inspection or Control is considered Handling.
It is always necessary to first disconnect and check for absence of voltage.
The "5 Golden Rules" must be adhered to.
30
Installation manual
ABB2000IKI01
Advertisement
Table of Contents
