Changing; Air Filter; Removal - Mercury 92‑813054A2 Manual

3. If the coolant is low in the coolant expansion tank, add the specified coolant as necessary to bring the level to within 25 mm
(1 in.) of the bottom of the fill neck.
b
a
Description
Marine Engine Coolant
Fleetguard Compleat with DCA4
IMPORTANT: When installing the pressure cap, be sure to tighten it securely to prevent coolant loss.
4. Install the pressure cap. Tighten securely.

Changing

Change (replace) the engine coolant at the prescribed interval. See Replacing the Engine Coolant in the Closed Cooling
System.

Air Filter

Removal

1. Loosen the clamp and remove the oil separator vent hose.
2. Loosen the clamp and remove the air filter housing from the turbocharger inlet.
b
90-8M0069748 APRIL 2012
eng
Where Used
Closed cooling system
a
c
25356
Fleetguard Part Number: CC2825
Air filter housing installed on engine
a - Air filter housing
b - Oil separator vent hose
c - Air intake retaining clamp
c
25357
Section 5 - Maintenance
Engine coolant fill location
(engine cover removed)
a - Pressure cap
b - Coolant expansion tank
c - Bottom of fill neck
Part Number
92‑813054A2
Europe Only
Obtain Locally
Page 55