Table of Contents
Advertisement
Checking the Remote's Gateway ID
Your remote can display the gateway ID currently
programmed into it. To display the remote's current
gateway ID, perform the following steps:
1.
Press MTS once. Then press and hold SETUP
until the MTS key blinks twice.
Enter 9 5 7.
2.
3.
To view the code for the first digit, press 1
once. Count the number of times the MTS key
blinks (e.g., 3 blinks = 3).
4.
Repeat step 3 two more times for the
remaining digits. Use 2 for the second digit,
and 3 for the third digit.
5.
Write the ID code number down for later
reference.
CLEARING CUSTOM PROGRAMMING
The Atlas DVR/PVR IR/UHF Remote contains a Custom
Programming Reset program. You can use it to remove
all custom programming, except your setup codes and
reassigned device keys.
IMPORTANT: Executing this program erases all custom
settings for Volume Lock, Learned Keys,
Tune-In Keys, and Channel Lock. However,
your device programming remains.
On the remote control, press and hold SETUP
1.
until the last-selected device key blinks twice.
Enter 9 8 0. The last-selected device key
2.
blinks twice, pauses, and blinks twice again to
confirm that all custom programming is
cleared.
22
Advertisement
Table of Contents
