Wasp WPL618 Series User Manual page 53

This item is used to fine tune media stop location. Available
Tear Off
setting value range is from -120~120 dots.
This item is used to set the print mode. There are 3 modes as
below,
Print mode
This item is used to set print width. The available value range
Print Width
is 2 ~ 999 dots.
This feature is used to print current printer available fonts list
List Fonts
to the label. The fonts stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print current printer available images
List Images
list to the label. The images stored in the printer's DRAM,
Flash or optional memory card.
This feature is used to print current printer available formats
List Formats
list to the label. The formats stored in the printer's DRAM,
Flash or optional memory card.
This feature is used to print current printer configuration to the
List Setup
label.
Control Prefix
This feature is used to set control prefix character.
Format Prefix
This feature is used to set format prefix character.
Delimiter Char
This feature is used to set delimiter character.
This option is used to set the action of the media when you
turn on the printer.
Media Power Up
This option is used to set the action of the media when you
close the print head.
Head Close
This option is used to adjust print position vertically on the
Label Top
label. The range is -120 to +120 dots.
This option is used to adjust print position horizontally on the
Left Position
label. The range is -9999 to +9999 dots.
When reprint mode is enabled, you can reprint the last label
Reprint Mode
printer by pressing
Selects the bitmap scaling factor. The first number is the
Format Convert
original dots per inch (dpi) value; the second, the dpi to which
Printer Mode Description
Next label top of form is aligned to the print
Tear Off
head burn line location.
Peeler Off Enable the label peel off mode.
Cutter Enable the label cutter mode
Rewind Enable the label rewind mode
Selections Description
Feed
Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length Printer determine length and feed label
No Motion Printer will not move media
Selections Description
Feed Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length Printer determine length and feed label
No Motion Printer will not move media
button on printer's control panel.
- 44 -
0 dot
Tear Off
812
N/A
N/A
N/A
N/A
N/A
N/A
N/A
No Motion
No Motion
0
0
Disabled
None