Table of Contents
Advertisement
Battery pack operation
Installing and charging the battery
3. Check that the mains voltage is the same as that marked on the rating plate of the
battery charger. Then, insert the charger's plug into the electrical wall outlet. When
you plug in the charger, the top green light will illuminate and stay green.
4. Place the battery pack into the charger. When you insert the battery into the
charger, the bottom red light will illuminate to indicate that the battery is charging.
5. When the bottom light turns green, the battery is fully charged.
6. The battery charge indicator lights on the battery pack will display as the pack is
charging to indicate the battery's capacity.
7. After charging is complete, the continuous green light will turn on and the charge
level indicator on the battery will turn off.
8. If the charging light indicator alternately blinks red and green or the light indicator
does not come on at all, check that the battery pack is fully seated into the
charger.
9. When charging is complete, remove the battery from the charger.
10. Timely recharging of the battery will help prolong the battery's life. You must
recharge the battery pack when you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully discharged as this
will cause irreversible damage to the battery.
Operation
IMPORTANT! The lawn mover is equipped with a safety circuit to prevent
unauthorised use. Directly before starting up the lawn mower, insert the safety
key into the slot found on the switch box (See Fig. 7) and remove the safety key
again whenever you interrupt or terminate your work.
To prevent the equipment switching on accidentally, the lawn mower is equipped with
a safety switch button, which must be pressed before the ON/OFF switch bar lever
can be activated.
24
Fig. 7
Advertisement
Table of Contents
