Table of Contents
Advertisement
Installation Guide
Power Monitoring
E50H2A, E50H5A
Quick Setup
Instructions
ZL0117-0D
Page 10 of 28
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Use this section to enter:
- BACnet communication parameters
- CT (Current Transducer) output voltage
- The service type to be monitored
These instructions assume the meter is set to factory defaults. If it has been previously configured, check all optional values.
A. To Navigate to the Setup screens:
+
–
1. Press
+
or
repeatedly until SETUP screen appears.
2. Press
to get to the PASWD screen.
3. Press
to move through the digits. Use the
4. Press
to move to the first Setup screen (S BAC)
+
–
5. Use
+
or
to select the parameter screen you want to set.
6. After you set the parameters you want, use
SETUP).
B. To Enter BACnet communication parameters
1. Navigate to the S BAC (set BACnet) Setup screen (see section A above).
2. Press
to go to the MAC screen and through the address digits. Use
001).
3. Press
to accept the value and go to the KBAUD screen. Use
4. Press
to go to the ID1 screen and through the upper four digits of the Device Instance. Use
The setup screen splits the Device ID into two parts, the most significant four digits (ID1) and the least significant three digits
(ID2). The E50HxA supports BACnet Device ID values from 1 to 4,193,999. Units are shipped with a factory default setting that is
pseudo-randomly generated in the range from 1,000,000 to 3,097,151.
5. Press
to accept the value and go to the ID2 screen and through the lower three digits of the Device Instance. Use
select the ID digits.
6. Press
to accept the value and go back to the S BAC screen.
C. To Enter the CT (Current Transducer) output voltage and input current ranges:
1. Press
to go to the CT V screen. Use
1.00).
2. Press
to go to the CT SZ screen and through the digits. Use
the value and
3. Press
to accept the value and go back to the S CT screen.
D. To Enter the service type to be monitored:
1. Navigate to the S SYS (Set System) Setup screen (see section A above).
2. Press
to go to the SYSTM screen. Use
Press
to go back to the S SYS screen.
For full setup instructions, see the configuration instructions on the following pages.
©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
+
–
+
or
buttons to enter your password (the default is 00000).
+
–
+
or
to select the next Setup screen or
+
–
or
+
+
–
+
or
to select the baud rate (default is 76.8K).
+
–
+
or
to select the voltage mode Current Transducer output voltage (default is
–
+
or
to select the CT size in amps (default is 100). accept
+
+
–
or
to select the configuration (see wiring diagrams - default is 3LN-1N).
+
to exit the Setup screens (return to
to select the BACnet MAC address (default is
+
–
+
or
to select the ID digits.
TM
+
–
or
to
+
08131
Advertisement
Table of Contents
