Table of Contents
Advertisement
Installation Guide
Power Monitoring
E50B1, E50C2, E50C3
Quick Setup
Instructions
ZL0103-0C
Page 10 of 26
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Find Quality Products Online at:
These instructions assume the meter is set to factory defaults. If it has been previously configured, all optional values should be
checked.
+
–
1. Press the
or
button repeatedly until SETUP screen appears.
+
2.
to the PASWD screen.
+
3.
through the digits. Use the
+
or
+
–
4. Use the
or
buttons to select the parameter to configure.
+
5. If the unit has an RS-485 interface, the first Setup screen is S COM (set communications).
a.
to the ADDR screen and through the address digits. Use the
b.
to the BAUD screen. Use the
c.
to the PAR screen. Use the
d.
back to the S COM screen.
–
to the S CT (Set Current Transducer) screen. If this unit does not have an RS-485 port, this will be the first screen.
6.
a.
to the CT V screen. Use the
b.
to the CT SZ screen and through the digits. Use the
c.
back to the S CT screen.
–
to the S SYS (Set System) screen.
7.
a.
to the SYSTM screen. Use the
b.
back to the S SYS screen.
–
8. (Optional)
to the S PT (Set Potential Transformer) screen. If PTs are not used, then skip this step.
a.
to the RATIO screen and through the digits. Use the
ratio.
b.
back to the S PT screen.
–
to the S
V (Set System Voltage) screen.
9.
a.
to the VLL (or VLN if system is 1L-1n) screen and through the digits. Use the
System Voltage.
b.
back to the S V screen.
10. Use the
to exit the setup screen and then SETUP.
11. Check that the wrench is not displayed on the LCD.
a. If the wrench is displayed, use the
b.
through the screens to see which alert is on.
For full setup instructions, see the configuration instructions on the following pages.
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
GlobalTestSupply
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.
–
buttons to select the password (the default is 00000). Exit the screen to the right.
+
or
+
+
–
or
buttons to select the baud rate.
+
+
–
+
or
buttons to select the parity.
+
–
+
or
buttons to select the voltage mode Current Transducer output voltage.
+
–
+
or
buttons to select the CT size in amps.
+
–
or
buttons to select the System Type (see wiring diagrams).
+
+
–
or
buttons to select the Potential Transformer step down
+
+
–
+
or
buttons to find the ALERT screen.
.com
–
buttons to select the Modbus address.
+
–
+
or
buttons to select the Line to Line
sales@GlobalTestSupply.com
TM
09141
- Quick Links:
- Wiring
Hide quick links:
Advertisement
Table of Contents
