Policy Example - ZyXEL Communications XS3800-28 User Manual

Table 104 Advanced Application > Policy Rule (continued)
LABEL
Out-of-profile
action
Add
Cancel
Clear
Index
Active
Name
Classifier(s)
Delete
Cancel

22.3 Policy Example

The figure below shows an example Policy screen where you configure a policy to limit bandwidth and
discard out-of-profile traffic on a traffic flow classified using the Example classifier (refer to
on page 263).
Chapter 22 Policy Rule
DESCRIPTION
Select the actions to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP value to replace the DSCP field with the value specified in the Out of
profile DSCP field.
Select Set Out-Drop Precedence to mark out-of-profile traffic and drop it when network is
congested.
Select Do not drop the matching frame previously marked for dropping to queue the frames
that are marked to be dropped.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
This field displays the policy index number. Click an index number to edit the policy.
This field displays Yes when policy is activated and No when is it deactivated.
This field displays the name you have assigned to this policy.
This field displays the names of the classifier to which this policy applies.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
XS3800-28 User's Guide
268
Section 21.5