Maximum Nulling; Auto Nulling; Positive Placement System; Setting The Spinner Speed Sensor "Pulses Per Revolution - Bosch Rexroth CS 440RC Detailed Configuration And Set-Up Manual

9.4.2 Maximum Nulling

9.4.2 9.4.2 9.4.2 Maximum Nulling Maximum Nulling Maximum Nulling
Using the Down navigational arrow move the cursor in front of "Max Out". Press
•
the Enter button and using the navigational arrow move the cursor under the
last digit.
The conveyor should now be turning.
•
Using the navigational arrows adjust the spinner speed to the maximum speed
•
required during the spreading operation.
The reading on the screen is % of maximum controller output allowed,
•
permitting the spinner motor to operate to this maximum speed only.
Press the Enter button to return the cursor in front of the Max reading.
•
Press the Escape button once to return to the previous screen.
•
9.4.3 9.4.3

Auto Nulling

Auto Nulling
9.4.3 9.4.3 Auto Auto Nulling Nulling
Auto nulling of the spinner is possible only if the spinner is equipped with a speed
sensor.
9.5

Positive Placement System

9.5.1 9.5.1 Setting the Spinner Sp

Setting the Spinner Speed Sensor "Pulses per Revolution"

9.5.1 9.5.1 Setting the Spinner Sp Setting the Spinner Sp
Insert the programming key, select "SENSORS AND VALVES", select "SPINNER
SETUP" and select "SPINNER SENSOR". The screen to the left will appear.
Determine the "pulses per Revolution" from the manufacturer's specifications.
•
Use the Up or Down navigation button to move the cursor in front of "0022
•
Pulses/Rev" and press the Enter button.
Using the Left or Right navigation button, move to the number to be changed.
•
Using the Up or Down navigation button, change the number as required.
•
Once all the numbers have been changed, press the Enter button.
•
Press the Escape button three times to return to the first screen.
•
9.5 9.5.2 .2 .2 .2 Setting the Spinner

Setting the Spinner Maximum RPM

9.5 9.5 Setting the Spinner Setting the Spinner
Insert the programming key, select "SENSORS AND VALVES", select "SPINNER
SETUP" and select "VALVE SETTING". The screen to the left will appear.
Determine the hydraulic motor's maximum speed from the manufacturer's
•
specifications.
Use the Down navigation button to move the cursor in front of "0500 – Max
•
RPM" and press the Enter button.
Using the Left or Right navigation button move to the number to be changed.
•
Using the Up or Down navigation button, change the number as required.
•
Once all the numbers have been changed, press the Enter button.
•
Press the Escape button three times to return to the first screen.
•
eed Sensor "Pulses per Revolution"
eed Sensor "Pulses per Revolution" eed Sensor "Pulses per Revolution"
Maximum RPM
Maximum RPM Maximum RPM
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
31/57