Bosch Rexroth CS 440RC Detailed Configuration And Set-Up Manual page 18

Drive the vehicle at the speed entered above, once the vehicle is steady at this
speed press the Enter button and the screen to the left will appear.
Hold the vehicle speed steady while this screen is on the display, once this screen
disappears and returns to the previous screen, the calibration is complete.
The speed at which you are driving will now be reflected on the screen in the lower,
right hand corner.
4.1.6 6 6 6 Verification of Ground Speed 4.1. Verification of Ground Speed
4.1. 4.1. Verification of Ground Speed Verification of Ground Speed
If ground speed verification is carried out, for example using a hand held GPS
navigator and the ground speed is found to be inaccurate, an adjustment in the
pulses per KM or Mile can be made on the "SPEED INPUT" screen to correct this.
During the verification process the screen to the left would be on the display.
While driving the vehicle, the vehicle speed reading on this screen is compared to
the GPS speed reading.
If the speed calibration is off, Press the Enter button to enter the SPEED INPUT
•
phase.
Using the Left or Right navigation button, move the cursor under the number to
•
be changed.
Using the Up or Down navigation button, change the pulses per kilometer or
•
mile as required to correct the inaccuracy.
Once all the numbers have been changed, press the Enter button.
•
Press the Escape button three (3) times to return to the first screen.
•
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
18/57