Bosch Rexroth CS 440RC Detailed Configuration And Set-Up Manual page 55

19. Do engines need to be ramped up to normal RPM inst 19. 19. 19. Do engines need to be ramped up to normal RPM instead of idle RPM Do engines need to be ramped up to normal RPM inst Do engines need to be ramped up to normal RPM inst
during nulling? during nulling? during nulling? during nulling?
It is recommended to ramp up engine RPM to ensure sufficient hydraulic flow for
valves to operate. Possibly for vehicles with bigger pumps there is enough hydraulic
flow at idle RPM.
20. What types Temp Sensors do CS 20. 20. 20. What types Temp Sensors do CS What types Temp Sensors do CS- - - - 440RC cont What types Temp Sensors do CS
Currently the CS-440RC controllers support two types of Infra-re temp sensors,
Sprague Roadwatch and 996D Temp sensor from Controls Products Inc.
21. 21. What are the pin outs of the CS What are the pin outs of the CS- - - - 440RC digital inputs?
21. 21. What are the pin outs of the CS What are the pin outs of the CS
For Solid + + + + Pre For Solid Pre- - - - wet Operation wet Operation
For Solid For Solid Pre Pre wet Operation wet Operation
1 – Material Detection
2 – Material Change
3 – Low Liquid Pressure
4 – Plow Indicator
5 – Spare
6 – P-Float Indicator
7 – Low Oil Indicator
8 – Body Up Indicator
22. The Display screen is blank: 22. The Display screen is blank:
22. 22. The Display screen is blank: The Display screen is blank:
If the power switch light is not illuminated then:
Possible sensor or solenoid short circuit
•
Possible extender cable short circuit
•
Unplug peripheral sensors and solenoids until problem goes away
•
Replace defective sensor/solenoid
•
There is a time delay breaker in the knob console that may take a few seconds to
trip upon a fault condition. This will cause the display to blank. The breaker will
reset when the fault is corrected.
Some severe short circuits or circuit misuse can cause damage to the knob console.
If the power switch remains illuminated then:
Unplug peripheral cables on the back of the display (i.e. temp sensor, GPS,
•
digital input cable)
Check/replace the short interconnect between the display and the knob console
•
If problem persists, the console may require service form the factory
•
ead of idle RPM ead of idle RPM ead of idle RPM
440RC controllers support? 440RC cont 440RC cont rollers support? rollers support? rollers support?
440RC digital inputs?
440RC digital inputs? 440RC digital inputs?
For An For Anti ti ti ti- - - - Icing Operation Icing Operation
For An For An Icing Operation Icing Operation
1 – Left Boom
2 – Liquid Change
3 – Low Liquid Pressure
4 – Right Boom
5 – Centre Boom
6 – P-Float Indicator
7 – Low Oil Indicator
8 – Body Up Indicator
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
55/57