Operator Option Configuration; Presetting The Gate Opening; Presetting The Material Selection - Bosch Rexroth CS 440RC Detailed Configuration And Set-Up Manual

13

Operator Option Configuration

The number of inputs to be set by the operator can be limited depending on the
requirements of the vehicle.
The options are:
None
•
Mat
•
Gate
•
Mat + Gate
•
Mat + Gate + Mode
•
If, for example the vehicle will spread all materials using the same gate setting, the
Gate setting option can be removed from operator access. Before removing the
operator access the function must be set as follows.
13.1

Presetting the Gate Opening

Insert the programming key, select "SYSTEM SETUP", select "OPERATION
SETTINGS" and select "GATE SETTING". The screen to the left will appear.
Use the Down navigation button to move the cursor to "05" and press the Enter
•
button.
Using the Left or Right navigation button, move to the number to be changed.
•
Using the Up or Down navigation button, change the number as required.
•
Once all the numbers have been changed, press the Enter button.
•
Press the Escape button three times to return to the first screen.
•
13.2

Presetting the Material Selection

Insert the programming key, select "SYSTEM SETUP", select "OPERATION
SETTINGS" and select "SOLID SELECT". The screen to the left will appear.
Use the Down navigation button to move the cursor to "Material to be selected" and
press the Enter button.
Press the Escape button twice to return to the first screen.
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
43/57