Description Of Parts; Using Your Tamper - Wilfa POWER FUEL PB-1200S Operating Instructions Manual

6

Description of parts

Measuring cup
1
Lid
2
Blender jug
3
Blade assembly
4
Blade Mount
5
Drive Gear
6
Blender Jug Seat
7
Top Cover
8
Circular trim
9
Pulse/start/stop button
10
Speed Dial
11
Motor unit
12
Power cord
13
Bottom cover
14
Anti-skid rubber foot
15
16
Tamper
16
11
13
1
2
3
4
5
6
7
8
9
10

Using Your Tamper

The tamper is to be used for stirring food and reading the food temperature
in the blender jar.
Never use the tamper without the lid in place. Remove the iller cap from
the lid and slide tamper into the Blender Jar. The tamper has a splash guard
located near the top that prevents the tamper from coming in contact with
the blade assembly.
The maximum temperature for the tamper is 212ºF. To take a temperature
reading simply press the temperature button located on top of the tamper.
The temperature is read by a sensor located at the bottom of the tamper.
You can turn the temperature sensor off by pressing the temperature button;
otherwise it will automatically shut off after 2 minuttes. To change between
Celsius and Fahrenheit press the button on the top of the tamper for more
than 3 seconds.
Changing the Tamper Battery
1. Open the Top Cover by turning counter-
clockwise.
2. Remove the PCB Assembly from the
Tamper being careful not to pull the wire
connector.
3. Locate the battery on the underside of the
PCB Assembly. Slide out the battery from
under the bracket. Slide a new battery into
the bracket and replace the PCB Assembly
and Top Cover. Use only battery type
CR2032.
1.Temperature Button
2. Top Cover
3. PCB Assembly
4. Battery
5. Decorative Ring
12
6. Handle
7. Splash Guard
14
8. Tamper Stem
15
9. Temperature Sensor (located underneath)
7
➋
➊
➌
➍
➎
➏
➐
➑
➒