Inserting A Sd Memory Card; Installation - Idis DC-D4831HRX Quick Manual

Inserting a SD Memory Card

Insert a SD memory card into the SD memory card slot
with the 'micro SD' print facing upward.
Push the SD memory card until it disengages from
the slot, and then pull it out.
micro SD Logo is a trademark of SD-3C, LLC.

Installation

• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall
or ceiling is not strong enough to support its
weight.
• Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Detach the protrusion part from the cable rubber
along the dotted line.
2
Make the LAN cable go through the cable rubber
using the protect connector.
6
It is recommended to use lubricant to move
the LAN cable smoothly.
3
Pull the cable slightly and arrange the rubber as
shown below.
To pass through a thin cable or more than two
cables, it is advised to finish it using silicon to make
sure waterproofed perfectly. (Silicon finishing part
— refer to bottom image.)
4
Assemble the cable rubber to the bottom cover.
Quick Guide