Safety Precautions WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Important Safeguards 1. Read Instructions 10. Overloading All the safety and operating instructions should be read before the Do not overload wall outlets and extension cords as this can result appliance is operated.
IDIS Co., Ltd. reserves all rights concerning this document. Use or duplication of this document in part or whole without the prior consent of IDIS Co., Ltd. is strictly prohibited. Contents of this document are subject to change without prior notice for reasons such as functionality enhancements.
Guide Pattern DC-D4538WRA Safety Wire Screw ( only) Please download software (IDIS Discovery, IDIS Center, IDIS Solution Suite Compact) and product manual from this link : - IDIS Website (www.idisglobal.com) - Search IDIS Discovery, IDIS Center, IDIS Solution Suite Compact. Overview DC-D4538WRA •...
Page 5
Body DC-D4538WRA DC-D4538RA IR LED Network Port Dome Cover Assembly Lens Part Factory Reset Button Alarm I/O, Audio I/O Built-in Microphone SD Memory Card Slot Wall/Ceiling Cable Rubber Installation Hole Power Network Camera...
Remove the dome cover. Inserting an SD Memory Card Insert an SD memory card into the SD memory card slot with the ‘micro SD’ print facing upward. DC-D4538RA DC-D4538WRA Loosen the screws counterclockwise using the Allen wrench provided with the product. Quick Guide...
DC-D4538WRA DC-D4538RA Use the screws, anchor provided with the camera to secure the install body on a wall or a ceiling. Use the provided guide pattern to check the distance between the screws. Push the SD memory card until it disengages from the slot, and then pull it out.
Page 8
Detach the protrusion part from the cable rubber along the dotted line. Make the LAN cable go through the cable rubber using the protect connector. Attach the enclosed desiccant in the bottom to prevent moisture. It is recommended to use lubricant to move the LAN cable smoothly.
Attach the dome cover to the bottom cover in a straight line.Turn the dome cover clockwise to fasten the dome cover. DC-D4538WRA Attach the double-sided tape to the desiccant first, and attach it to the specified location inside the dome cover as shown below.
Page 10
Remove the protective film inside and outside before closing the dome cover.
Need help?
Do you have a question about the DC-D4538WRA and is the answer not in the manual?
Questions and answers