Grandstream Networks GSC362 Series User Manual page 41

Use Random Port
Auto On-Hook Timer
Ring Timeout(s)
SIP TLS Certificate
SIP TLS Private Key
SIP TLS Private Key
Password
Enable Direct IP Call
Enable two-way SIP
Calling
SIP Proxy Compatibility
Mode
SIP Packetization
Compatibility Mode
Enable Multi-channel
Call Mode
Allow Reset Via SIP
NOTIFY
Forces the GSC362X to use random ports for both SIP and RTP
messages. This is usually necessary when multiple units are behind the
same full cone NAT. The default setting is "Disabled"
Note: This parameter must be set to "Disabled" for Direct IP Calling to
work.
Configures the auto on-hook timer (in seconds) for automatic
disconnecting the SIP call. Default setting is 300. Range between
0~65535.
Specifies the Ring timeout, when no reply is returned from the called party
after exceeding this field, the GSC362X will hang up the call. The value is
in the range of 0s – 90s. By default, it is "30" seconds.
Input the TLS certificate here for encryption.
Input private key here for TLS security protection.
Specifies the password for SIP TLS private Key.
Accepts peer-to-peer IP call (over UDP only) without SIP server.
Default is "Enabled".
Allows the user to enable/disable the alarm sound during a SIP call
triggered by doorbell pressing.
Enables more proxy compatibility with cost of bandwidth, the SIP call will
send audio no matter what.
When enabled, the GSC362X will have in SDP "packetization-mode = 0".
This is required when the device is interacting with legacy video phones
that only accepts this value to decode the RTP.
This feature allows the device to receive multiple calls at the same time,
with one active and others on hold (up to 4 calls maximum).
Allows to factory reset the devices directly through SIP Notify.
If "Allow Reset Via SIP NOTIFY" is "check", then once the GSC3620/3625
receives the SIP NOTIFY from the SIP server with Event: reset, the device
will perform a factory reset after authentication.
This authentication can be either with:
The admin password if no SIP account is configured on the unit.
•
The SIP User ID and Password credentials of the SIP account if
•
configured on the unit.
Default is unchecked (disabled).
GSC362X Series User Manual
Version 0.0.0.5
P a g e | 41