Ethernet Settings; Figure 4-5 Wireless Network Connected Successfully; Figure 4-6 Ethernet Settings - hanshow HS-AT2311 Product Manual

Hanshow Shelf Edge Digital Signage HS-AT2311 Product Manual
Configuration item
IP address
Gateway
Network prefix length
DNS
After the configuration is complete, tap the Save button. The system automatically
connects to the wireless network according to the configurations. If the connection is
successful, the screen displays "Connected", as shown in

Figure 4-5 Wireless network connected successfully

Ethernet settings

4.1.2
Follow the steps below to configure Ethernet connection:
1. Tap Ethernet to open the Ethernet settings page.
2. On the upper-right corner of the page, tap the switch to turn on the Ethernet
connection function. Ethernet settings also support DHCP and static IP settings, as
shown in Figure
13
IP address, can be configured when IP setting is set to static.
Gateway address, can be configured when DHCP is selected for IP
settings.
The bit length of the network prefix, usually 24, can be configured
when DHCP is selected for IP settings.
Domain name servers, including DNS1 and DNS2. DNS1 is the
primary DNS server. Only when DNS1 cannot find IP addresses
corresponding to domain names or when DNS1 is unavailable, can
DNS2 configuration take effect. This configuration item can be
configured when DHCP is selected for IP settings.
4-5.

Figure 4-6 Ethernet settings

Description
Figure 4-5.
Hanshow Copyright Reserved ©
Zhejiang Hanshow Technology Co., Ltd.