Operations; Network Settings; Wi-Fi Settings; Figure 4-1 Network Settings Selection Page - hanshow HS-AT2311 Product Manual

Hanshow Shelf Edge Digital Signage HS-AT2311 Product Manual

4 Operations

This chapter describes network settings and system upgrade of HS-AT2311.

4.1 Network settings

HS-AT2311 currently only supports direct operation of the device for network settings.
HS-AT2311 support both Wi-Fi and Ethernet connections. You can configure network
environment according to actual use scenarios.
1. On the device's system desktop, tap Settings to open the Settings page, as shown
in Figure 4-1.
2. Select Wi-Fi or Ethernet according to your network requirements.

Wi-Fi settings

4.1.1
Follow the steps below to configure Wi-Fi network connection:
1. Tap Wi-Fi to open the wireless network settings page.
2. On the upper-right corner of the page, tap the switch to turn on the Wi-Fi connection
function. The system automatically searches for available wireless networks, and
then lists available network access points, as shown in
3. Tap the access point you want to connect. The setting page for the selected wireless
network opens.
4. If static IP setting is not required, enter the wireless network password directly, and
then tap the Complete button on the soft keyboard. The system automatically
11

Figure 4-1 Network settings selection page

Figure 4-2 Turn on wireless network connection

Figure 4-2.
Hanshow Copyright Reserved ©
Zhejiang Hanshow Technology Co., Ltd.