Arcconf Setncq; Arcconf Setperform; Arcconf Setpower - Adaptec 5405Z User Manual

Example
ARCCONF SETNAME 1 LOGICALDRIVE 1 BACKUP_A

arcconf setncq

Changes the controller's Native Command Queuing (NCQ) setting to enabled or disabled.
This setting affects the SATA disk drives on the controller. It takes effect when the SATA drives
are restarted.
Syntax
ARCCONF SETNCQ <Controller#> ENABLE|DISABLE
Parameters
Controller# is the controller number.
Example
ARCCONF SETNCQ 1 ENABLE

arcconf setperform

Changes controller settings based on the application.
Syntax
ARCCONF SETPERFORM <Controller#> <Performance Mode>
Parameters
Controller# is the controller number.
Performance Mode is 1 (DYNAMIC/Default) or 2 (OLTP/Database).
Example
ARCCONF SETPERFORM 1 2

arcconf setpower

Changes power management settings for disk drives on a controller or logical drive.
Syntax
ARCCONF SETPOWER <Controller#> Stayawake DISABLE|<starttime> <endtime>
ARCCONF SETPOWER <Controller#> Spinup <internal#> <external#>
ARCCONF SETPOWER <Controller#> LD <LogicalDrive#> DISABLE|[SLOWDOWN <st#>]
[POWEROFF <pt#>] [VERIFY <vt#>]
Parameters
Controller# is the controller number.
Stayawake sets the stayawake period for the disk drives on the controller. During the stayawake
period, the disk drives always operate at their peak spin rate.
Disable is a keyword that disables the stayawake period for the disk drives on a controller.
starttime specifies the beginning of the stayawake period, in the form HHMM (24-hour
format).
endtime specifies the end of the stayawake period, in the form HHMM (24-hour format).
Spinup sets the spin-up limits for the controller—the maximum number of drives that the
controller may spin up at one time.
Chapter 2: Using the Command Line Utility
22
●