arcconf setcache
Changes a logical drive's cache mode.
Syntax
ARCCONF SETCACHE <Controller#> LOGICALDRIVE <LogicalDrive#> <logical mode>
[noprompt]
ARCCONF SETCACHE <Controller#> DEVICE <Channel> <ID> <physical mode>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive whose cache will be altered
Logical drive cache modes:
RON - read cache on
●
ROFF - read cache off
●
WT - write through disabled
●
WB - write back enabled
●
WBB - write back enabled (when protected by a battery)
●
Channel/ID lists the space-delimited channel number and device number pairs for each device
to add to the logical drive.
Physical device cache modes:
WT - write through disabled
●
WB - write back enabled
●
Examples
ARCCONF SETCACHE LOGICALDRIVE 1 RON
ARCCONF SETCACHE DEVICE 0 0 WB
arcconf setconfig
Resets the controller's configuration. Logical drives are deleted, hard disks are reset to the
READY state, and any controller settings are reset to default values.
Syntax
ARCCONF SETCONFIG <Controller#> DEFAULT [noprompt]
Parameters
Controller# is the controller number
Default restores the controller 's default configuration.
Noprompt: No prompt for confirmation.
Example
ARCCONF SETCONFIG 1 DEFAULT
Chapter 2: Using the Command Line Utility
22
●