Setting U Pscsi Devices - Adaptec 29160 Installation Manual

Installation Guide
Computers may have vertical or horizontal expansion slots. Refer
to your computer manual to locate the PCI slots. If your com-
puter is a tower model, lay it on its side to allow for easier
installation of the Adaptec SCSI Card 39160.
W
39160 in a PCI slot. Some 32-bit slots will not accommodate
it, and the card may break if you force it into the slot.
Insert the Adaptec SCSI Card 39160 in the 64-bit (or 32-bit) PCI
S 4
TEP
expansion slot; press down firmly until the card clicks into place,
then replace the slot cover screw. When installed properly, the
card should appear level with the expansion slot, as shown below.
S U
ETTING
There are several things you may need to do to your SCSI devices
before you connect them to the Adaptec SCSI Card 39160:
•
•
•
Since setup can vary from device to device, always refer to the
device's documentation for specific instructions.
4
ARNING
Be careful when inserting the Adaptec SCSI Card
SCSI D
P
Check the SCSI IDs
Set the termination
Connect the power cables
EVICES