Setting U Pscsi Devices - Adaptec 29320-R Installation Manual

Computers may have vertical or horizontal expansion slots. Refer
to your computer manual to locate the PCI/PCI-X slots. If your
computer is a tower model, lay it on its side to allow for easier
installation of the Adaptec SCSI Card 29320.
W
ARNING
29320 in a PCI slot. Some 32-bit slots will not accommodate it,
and the card may break if you force it into the slot.
Insert the Adaptec SCSI Card 29320 in the 64-bit (or 32-bit) PCI or
S 4
TEP
PCI-X expansion slot; press down firmly until the card clicks into
place, then replace the slot cover screw. When installed properly,
the card should appear level with the expansion slot, as shown
below.
S U
ETTING
There are several things you may need to do to your SCSI devices
before you connect them to the Adaptec SCSI Card 29320:
•
Check the SCSI IDs
•
Set the termination
•
Connect the power cables
Since setup can vary from device to device, always refer to the
device's documentation for specific instructions.
Below are some guidelines for setting SCSI IDs and termination
on your devices.
Be careful when inserting the Adaptec SCSI Card
SCSI D
P EVICES
3