Adaptec 29160 Installation Manual page 11

Connecting Internal Ultra/Fast Narrow SCSI Devices
C
AUTION
the three SCSI Channel A connectors at the same time.
If you have internal Ultra/Fast Narrow SCSI devices with stan-
dard 50-pin connectors, you can connect them to the 50-pin
internal SE Narrow SCSI connector. Follow these steps to connect
the devices:
Locate a 50-pin internal Ultra Narrow SCSI cable.
S 1
TEP
Plug one end of the cable to the 50-pin internal SE Narrow SCSI
S 2
TEP
connector, positioned vertically on the right side of the Adaptec
SCSI Card 39160 (refer to the figure on page 1).
Plug the other end of the cable to a terminated Ultra/Fast Narrow
S 3
TEP
SCSI device.
If you have other Ultra/Fast Narrow SCSI devices, attach them to
S 4
TEP
the connectors between the two ends of the cable. Be sure these
other devices are un-terminated.
Connect a power cable from your computer's internal power sup-
S 5
TEP
ply to each internal device.
Do not connect SCSI devices to more than two of
Adaptec SCSI Card 39160
9