Setting U Pscsi Devices; Check The Scsi Ids - Adaptec 39320-R Manual

Insert the Adaptec SCSI Card 39320 in the 64-bit (or 32-bit) PCI or
S 4
TEP
PCI-X expansion slot; press down firmly until the card clicks into
place, then replace the slot cover screw. When installed properly,
the card should appear level with the expansion slot, as shown
below.
S U
ETTING
There are several things you may need to do to your SCSI devices
before you connect them to the Adaptec SCSI Card 39320:
•

Check the SCSI IDs

•
Set the termination
•
Connect the power cables
Since setup can vary from device to device, always refer to the
device's documentation for specific instructions.
Below are some guidelines for setting SCSI IDs and termination
on your devices.
Check the SCSI IDs
The Adaptec SCSI Card 39320 and each device you connect to it
must have a unique SCSI ID number ranging from 0 to 15 on each
channel. No two devices on the same SCSI channel can have the
same SCSI ID.
SCSI D
P EVICES
4