Table of Contents
Advertisement
6
STEP
A. Connect the Leaf Spring that is to the right of a Joiner Pole into the mat
connector that is to the right of the Batch Tag.
B. Go to the other side of the frame and connect the Leaf Spring that is to
the right of the opposite Joiner Pole to its corresponding mat connector.
C. Go to one of the Joiner Poles directly between the two Leaf Springs
that you have connected. Attach the Leaf Spring to the right of it to its
corresponding mat connector.
Repeat for the Joiner Pole and right-hand Leaf Spring on the opposite side.
Tip: To use the Leaf Spring Tool, hook the lever over the Leaf Spring,
just beneath the natural bend in the Spring. Push the handle towards
the Jump Mat, and as the Spring bends, attach it to the mat connector.
D. Continue attaching Leaf Springs to the right of each Joiner Pole, before
attaching the corresponding opposite Leaf Springs.
Repeat for each Leaf Spring to the left of each Joiner Pole.
Remember: Avoid connecting the Leaf Springs sequentially around the
trampoline. This will make them more difficult to attach.
Safety Net
7
STEP
A. Unravel your Safety Net and lay it atop your
Jump Mat.
B. Find the Batch Tag on the Safety Net, and
rotate the Safety Net so that this Batch Tag
lines it up with the one on the Jump Mat.
Note: Ensure that the stitched belts on the
Safety Net are on the outside and that they
also line up with the Joiner Poles.
8
STEP
A. Unfasten the Leaf Springs
on either side of the Jump
Mat Batch Tag from their mat
connectors. Slip those mat
connectors through the net
connector holes on either side
of the Safety Net Batch Tag. Re-
attach the Leaf Springs.
B. Repeat for each Leaf Springs
and mat connector to the left
and right of every Joiner Pole.
A
A
A
B
C
B
B
13
Advertisement
Table of Contents
