Vuly Thunder Pro Manual page 12

STEP 3
A. Choose a Joiner Pole. Slide Lower Frame Tubes into both sides of
it and an Upper Frame Tube into the left side only.
B. Insert Leaf Springs into the holes in the Lower Frame Tubes that
are on either side of the Joiner Pole to secure the Lower Frame
Tubes and Joiner Pole together.
Note: Ensure that when you insert the Leaf Springs,
the locking plates face outwards.
Tip: If the Leaf Springs do not properly insert into
the Leaf Spring holes on either side of a Joiner
Pole, strongly tap the corner of the Joiner Pole on
the ground to realign the Leaf Spring slots.
4
STEP
Go around your trampoline, connecting each Lower and Upper
Frame Tube to each Joiner Pole.
Ensure that you insert the Leaf Springs on either side of the
Joiner Pole to secure the Lower Frame Tubes as you do so.
Check that they have firmly locked into place.
See that your completed frame matches the image.
Jump Mat and Leaf Springs
5
STEP
A. Unravel and lay your Jump Mat inside the
frame, ensuring that it is flat, with the print
facing upwards.
B. Find the Batch Tag on the Jump Mat, and
rotate the Jump Mat so that the Batch Tag
lines up with a Joiner Pole.
Note: The entrance will be between the two Joiner Poles to the right of
the Batch Tag. Rotate your Mat to the desired position, but always ensure
that the Batch Tag lines up with a Joiner Pole. The Vuly logo should be
centred between two Joiner Poles.
12
B
A
A
B