Setting Up Remote Access For The First Time; Setting Up Remote Access From The Directory Manager - Adaptec 2110S User Manual

Adaptec Storage Manager Pro User's Guide

Setting Up Remote Access for the First Time

To set up remote access, you must perform the following tasks in
sequence:
1
Register each system with the directory manager. See the steps
that follow.
2
Set up at least one global user account. See Adding User
Accounts on page 5-3.
Note:
All systems must have the same version of
Storage Manager Pro installed.
You can set up remote access from either of two systems on your
network:
I System that will become the directory manager
I System that will become a member of the new management set

Setting Up Remote Access from the Directory Manager

The instructions below assume you are setting up from the directory
manager, rather than from a member of the management set.
To set up remote access:
1
Decide which systems you want to be members of the
management set (not the directory manager) and start Storage
Manager Pro on those systems.
Write down the system name or IP address of each system you
want to be in the management set.
The Storage Manager Pro service (ASMProServer) or daemon
as well as the Storage Manager Pro software must be running
on those systems. After you install Storage Manager Pro, the
Storage Manager Pro service (ASMProServer) or daemon starts
automatically when you boot the system. See Starting Adaptec
Storage Manager Pro on page 1-3.
2
Start the Storage Manager Pro software on the system that you
want to be the directory manager.
See Starting Adaptec Storage Manager Pro on page 1-3.
4-4