Installing Or Updating Device Drivers After Installing Netware - Adaptec 1420SA Installation And User Manual

Installing or Updating Device Drivers After Installing NetWare

To update the driver in an existing NetWare 6.5 system see
Updating the Device Drivers on page
existing NetWare system, see
page 3-9.
Updating the Device Drivers
1 Reboot your system to DOS.
2 At the prompt, copy the drivers (
to:
c:\NWSERVER\DRIVERS\XXXX
where XXXX is the name of the driver.
3 Restart your system.
Installing the Device Drivers
1 Start the NetWare hdetect utility program. From the system
console, type the following, then press Enter:
load hdetect
2 Insert the HostRAID driver disk for Novell NetWare into the
floppy disk drive.
3 If you see the prompt
, select Yes, then press Enter to continue.
anyway?
4 When the next window appears, select, then press Enter.
5 The device driver window opens, select Continue, then press
Enter.
6 Highlight the driver under Storage adapters, then press Enter.
7 Select Modify, then press Enter.
8 If the driver
Delete key to delete it.
9 Press the Insert key twice to add a driver.
10 When the next window opens, press F3 to specify a different
path.
Installing the Device Drivers on
Sys volume not mounted. Load driver
exists, select the driver, then press the
AAR81XX
3-9. To install the driver in an
,
AAR81XX.DDI
Installing the Driver
)
AAR81XX.HAM
3-9