The Adaptec Controller
The following is a illustration of the Adaptec Serial ATA II
RAID 1420SA controller. Note the position of the Serial ATA
interface connectors necessary for attaching the Serial ATA disk
drives.
Mounting
Bracket
Installing the Controller
To install the controller in the system cabinet:
1 If you have a low-profile computer cabinet, replace the original
full-height bracket with the low-profile bracket supplied in the
controller kit.
2
Turn off your computer, unplug the power cord, and open the
system cabinet.
3
Remove the cover from an available PCI or PCI-X slot that is 2.2
or higher compliant.
Note: You'll get better performance if you use a 64-bit slot.
Installing the Controller
Internal Connectors
2-2