Table of Contents
Advertisement
English
§
condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:
§
Never perform wiring on a powered module.
§
Mounting the module should only be done in closed, clean, dry
rooms. Beware of humidity.
§
Only use low power for this module as described in this manual and
only use certified transformers.
§
Connect transformers and soldering irons only in approved mains
sockets installed by an authorised electrician.
§
Observe cable diameter requirements.
§
After condensation build up, allow a minimum of 2 hours for
dispersion.
§
Use only original spare parts if you have to repair the module.
Fire risk
Touching flammable material with a hot soldering iron can cause fire,
which can result in injury or death through burns or suffocation.
Connect your soldering iron or soldering station only when actually
needed. Always keep the soldering iron away from inflammable
materials. Use a suitable soldering iron stand. Never leave a hot
soldering iron or station unattended.
Thermal danger
A hot soldering iron or liquid solder accidentally touching your skin can
cause skin burns. As a precaution:
§
use a heat-resistant mat during soldering,
§
always put the hot soldering iron in the soldering iron stand,
§
point the soldering iron tip carefully when soldering, and
§
remove liquid solder with a thick wet rag or wet sponge from the
soldering tip.
Page 34
Basic
FD-R
Advertisement
Table of Contents
