Table of Contents
Advertisement
Basic
FD-R
Reset the central unit (by simultaneously pushing the buttons "stop"
and "go" for some time) or quickly switch the central unit off and on. First
enter the current address or the address "80" (e.g. if you do not know the
current address). Manufacturers setting is "3". Set all functions (function,
f1 to f4) to "off".
Push the "stop" button at the central unit. Next, operate the direction
switch and hold it in that position while briefly pushing the "go" button.
As soon as the lamps connected to the outputs AUX1 or AUX2 flash
(after approx. 2 seconds) the module is in the programming mode and
you an release the direction switch.
After having started the programming mode (and when the
locomotive´s lighting flashes) you can program the module´s registers
as follows:
1. Choose the register you want to programm by setting the register´s
number with the Motorola locomotive address at your central unit.
Please note that with some central units a leading "0" has to be
entered.
2. Operate the direction switch. The lighting stops flashing.
3. Set the desired value of the register by setting the register´s value
as Motorola locomotive address at your central unit.
4. Operate the direction switch again. The lighting starts flashing
again.
Repeat the steps 1 to 4 for all registers you want to program. In order
to choose a register for programming or to enter a value for a register
you have to confirm the entered number like selecting a Motorola
locomotive address. The lighting shows which kind of entry the module
expects:
§
lighting flashes à entry of a CV´s number
§
lighting stops to flash à entry of a CV´s value
In order to stop the programming mode push "stop".
English
Page 45
Advertisement
Table of Contents
