Table of Contents
Advertisement
Basic
FD-R
11. Check list for trouble shooting
§
Parts are getting very hot and/or start to smoke.
!
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: Short circuit. The module is connected to
locomotive or carriage ground. à Check the connections. A short
circuit can result in irreparable damage.
Problems with the function decoder area of the FD-R
§
After programming, the FD-R
Possible cause: The set values for the CV are inconsistent.
à Perform a decoder reset and first test the decoder with the
default values. Program the decoder anew.
Possible cause: Instead of saving the settings into the function
decoder area the settings were saved into the RailCom area of the
Basic
FD-R
. à Program the function decoder area anew, making sure
that in CV#29 RailCom is set "off".
§
An output cannot be switched on.
Possible cause: The values set in CV# 53 to 54 for an output,
contradict one another. à Alter the values for CV #53 to 54.
§
The lighting does not correspond to the direction of travel.
Possible cause: The configuration data (CV29) of the locomotive
decoder in the train vary from the configuration data programmed
in the function decoder. à Change the programming or the
function or the deocder.
§
The decoder does not react in analogue mode.
Possible cause: The analogue mode is switched off. à Alter the
value for CV #29.
Basic
does not react as intended.
English
Basic
Page 55
Advertisement
Table of Contents
