Table of Contents
Advertisement
Basic
FD-R
Checking the package contents
Check the contents of the package for completeness immediately after
unpacking:
§
one module, with or without soldered connecting wires, depending
on the version.
§
one manual.
Required tools and materials
Make sure you have the following tools, equipment and materials ready
for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge,
§
a heat-resistant mat,
§
a small side cutter, a wire stripper and a pair of tweezers,
§
tin solder (0,5 mm. diameter),
§
wire (diameter: > 0,05 mm² for all connections).
2. Safety instructions
Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards
§
Touching powered, live components,
§
touching conducting components which are live due to malfunction,
§
short circuits,
§
connecting the circuit to another voltage than specified,
§
impermissibly high humidity,
English
Page 33
Advertisement
Table of Contents
