Table of Contents
Advertisement
Basic
FD-R
In order to change the CVs or the registers used in both the FD-R
and a decoder with the same address you can proceed as follows as
well:
RailCom on
RailCom off
RailCom on
Advice: When not using the FD-R
should be switched off.
Programming the RailCom area
TIP: When using the FD-R
RailCom transmitter, first program the function decoder area as
described in the previous section.
In order to program the RailCom area of the FD-R
switched on in CV#29 (DCC format) or in register #7 (Motorola
format). All settings made for this area can be fed back via RailCom to
special detectors. You can save in this RailCom area either the values of
CVs #1 to #205 of a DCC decoder (that is not compatible to RailCom)
or the registers #1 to #205 of a Motorola decoder (that is not
compatible to RailCom) or the settings from the function decoder area
Basic
of the FD-R
.
Reading out the decoder´s settings.
Programming the function decoder area of the
Basic
FD-R
. NB: Simultaneously you alter the respective
CVs or registers of the decoder with the same address.
Programming the decoder with the data read out
before. The settings are saved in the RailCom area of
Basic
the FD-R
only.
Basic
Basic
as a RailCom transmitter, RailCom
both as a function decoder and as
Basic
, RailCom must be
Page 47
English
Basic
Advertisement
Table of Contents
