Table of Contents
Advertisement
52
Installing and removing an I/O option
module
The I/O option modules (ESM and TSM) are located in the rear of the
enclosure. Follow these procedures to install and remove the module.
Installing an I/O option module
1.
Power off the host system and enclosure.
2.
Gently insert the I/O option module into the slot.
3.
Secure in place using the two fixing screws (torque setting 0.3Nm).
4.
Connect the cables as described in page 17.
Removing an I/O option module
1.
Power off the host system and enclosure.
2.
Disconnect all cables connected to the I/O module to be removed.
3.
Loosen the two fixing screws.
4.
Using the module handle, gently slide the I/O option module out
of the slot.
5 Installing and removing components
Advertisement
Table of Contents
