22
Single ESM and TSM configuration
This configuration can be cabled as either a Single (Joined) SCSI Bus or
as a Dual (Split) SCSI Bus configuration.
Cabling the single (joined) SCSI bus configuration
One host cable is required for this configuration. The length of the
host cable may be a maximum of 10 meters in length. When viewed
from the rear there should be an ESM installed in one I/O slot and a
TSM in the other.
Follow the procedures below to connect the cable (see figure below):
1.
Power off the enclosure and the host system.
2.
Attach one end of the cable to the connector on the ESM.
3.
Attach the other end of this cable to the host.
To Host
ID 7
ESM
The ESM and TSM can be in either I/O slot of the enclosure.
SCSI ID Assignments shown from front of enclosure.
Note: For more information on the host connectors, refer to the
documentation supplied with the host system.
3 Cabling and configuration
1
2
Mute
1
2
TSM