Table of Contents
Advertisement
Disassemble Altos G710
Removing the Housing
1.
Open the front door with the key in the clockwise direction.
2.
Press the release switch.
3.
Lift the front door and detach it from the chassis.
4.
Remove the two screws that secure the bezel
5.
Depress the plastic retention tabs to detach the front bezel from the chassis
6.
Release lever.
7.
Pull out the hard disk carrier from the cage
8.
Remove the two screws on each side to detach the HDD from HDD carrier.
9.
Slide the HDD unit from the HDD carrier.
10. Loosen the three thumbscrews located at the end of the side panel.
11. Slide the side panel slightly forward, then tilt it upward before detaching it from the chassis
Chapter 3
63
Advertisement
Table of Contents
