Mitsubishi Electric Climaveneta i-BX-004-013M Installation, Operation And Service Manual page 57

INSTALLATION AND CONNECTION OF N-THC ROOM CONTROL UNITS
• Close the cover A1 and secure it with the screw A2
• Plug in the 4-pin connector, figure (7)
• Replace the terminal, starting with the lower tabs, applying
a hinge movement. Make sure that the electrical wires are
7
N-THC room control unit address setting procedure
1
• Main display
4
• Press the knob to confirm
7
• Press the button to exit the programming
procedure
Wall
2
• Press the
seconds
5
• Press the knob
Room control unit address by system type
System type
1 high temperature zone
(HT1)
1 low temperature zone (LT1)
1 zone LT1 + 1 zone HT1
inside to ensure correct fastening (click on).
• Dimensions of A5 room controller figure (8).
8
x3 sec.
+ buttons together for 3
Address
11
14
14
11
143
8
3
• Turn the knob and select the password
(as shown in the table)
6
A
A Turn the knob to select the value
B Press the knob to confirm
Description
High temperature zone room
control unit
Low temperature zone room
control unit
Low temperature zone room
control unit
High temperature zone room
control unit
EN i-BX-(Y)_i-BX-N-(Y)
U I A
28
B
57